Application - Dead Flat Varnish can be applied by brush, roller or spray equipment. Do not apply when air and surface temperature are below 50ºF (10ºC) or high humidity conditions exist. Optimal application conditions are 60ºF-80ºF (16ºC-27ºC) and 30%-60% relative humidity. For most applications thinning is unnecessary. Stir thoroughly before use. Do Not Shake.

Brushing - Use a high-quality synthetic bristle brush.

Rolling - Use a high-quality, soft short nap roller.

Spraying - Use a HVLP sprayer powered with an air compressor. If thinning is necessary, add up to 10% (3 fl. oz./85ml) of water per quart/946ml of Exterior Dead Flat Varnish. When spraying, use a NIOSH approved respirator.

Dry Times - Dry-to-touch is in approximately 30 minutes, re-coat is in approximately two hours, and full cure is in approximately 12 hours. Thicker film, temperature below 60°F (16°C) and relative humidity above 50% may result in slower dry times.

Coverage - Approximately 350 to 450 sq. ft./Gal., 31.5-40.5m²/3.78 L.