Application: Stir thoroughly before using and occasionally when in use. Prime all necessary surfaces with an appropriate PPG primer prior to application of the product. When using more than one container of the same color, intermix to ensure color uniformity. Do not mix with solvent-type paints or with paint solvents. USE WITH ADEQUATE VENTILATION. KEEP OUT OF REACH OF CHILDREN. Read all label and Material Safety Data Sheet (MSDS) information prior to use. MSDS are available through our website or by calling 1-800-441-9695.

Application Equipment: Apply with a high quality synthetic brush, roller, paint pad, or by spray equipment. Where necessary, apply a second coat. Airless Spray: Pressure 2000 psi, tip 0.009” - 0.013”. Best results are achieved using a fine finish tip. Spray equipment must be handled with due care and in accordance with manufacturer’s recommendation. Highpressure injection of coatings into the skin by airless equipment may cause serious injury.

• Brush: High quality polyester/nylon brush
• Roller: 3/16” - 3/8” nap roller cover.

Thinning: No thinning required for airless or air-assisted airless application. Reduce 5-10% with clean water for conventional spray, HVLP and brush applications.

COVERAGE: Approximately 400 sq. ft./gal. (37 sq. m/3.78L) depending on surface texture and porosity.

Dry Microns: 36 microns Coverage figures do not include loss due to surface irregularities and porosity or material loss due to application method or mixing.

DRYING TIME: Dry time @ 77ºF (25ºC); 50% relative humidity.

• To Touch: 15 to 20 minutes
• To Handle: 1 hour
• To Recoat: After 2 hours