Modern Masters - Metal Effects - Primer
A unique water-based acrylic primer formulated to be used under the Metal Effects reactive systems.
Items that qualify for free shipping are sent FedEx ground. We deliver nationwide, see expedited transit times and our shipping rates by entering your shipping info on the checkout page.
Unlike other primers, it is especially formulated to block Metal Effects Patina Aging Solutions and Activators from reaching the metal, wood, or reactive substrate. This helps prevent the formation of rust or other oxidation products from forming under the paint film. Metal Effects Primer will also block out alkali salts, tannins, acid salts, or other unwanted contaminates from ‘bleeding through’ to the Metal Effects Reactive Metallic Paint film and causing adverse reactions and unwanted color changes in the oxidized finish. Metal Effects Primer can be brush, roll or spray applied.
Surface Preparation – Remove all loose, peeling paint. Patch and repair any surface imperfections before using the Metal Effects Primer. All surfaces should be sound, clean and free of oil, grease, wax, and other contaminants, and completely dry prior to priming. Surfaces previously primed require light sanding. Scuff sand any glossy surfaces. If unsure of the substrate, test a sample area to ensure the desired results. Some metal surfaces, such as bare aluminum, galvanized metal, or rusted or slag metals, will need a specialty primer from our recommended primer list, applied prior to the application of Metal Effects Primer. If this is the case, read the specific information for the recommended primer prior to beginning your project. Properly prime the clean, dry surface with the recommended primer and allow the surface to dry completely—preferably overnight. Then follow the directions for applying Metal Effects Primer. Note: Lower temperature and higher humidity will lengthen the dry and cure times of primers.
Application – Stir will before use and occasionally during application. DO NOT THIN! Apply at least two coats of Metal Effects Primer using a brush, roller or spray equipment. Do not apply in temperatures below 55°F/13°C or above 95°F/35°C.
Brushing: Use a high-quality brush recommended for water base primer.
Rolling: To roll use a high-quality 3/8” nap roller.
Spraying: To spray, use HVLP or quality airless spray equipment.
Taping – Use high quality, low-tack tape when taping over surfaces that have been previously painted.
Dry Times – Recoat time is approximately ½ hour. Dry time is approximately 12 hours. It is important that Metal Effects Primer is completely dry before applying Metal Effects Reactive Metallic Paint. (Drying times were recorded at 70°F and 50%RH): Note: Lower temperature and/or higher humidity will lengthen the dry and cure times.
Coverage – One gallon/3.78 liters will cover approximately 320 square feet/29.7 square meters. Approximately 1.5 mils dry film thickness per coat. A minimum of 3 mils dry film thickness is required.
Clean Up – Clean brushes, rollers, tool, and equipment with soap and warm water immediately after use. Do not reuse containers and properly dispose of empty containers. VOC – Metal Effects Primer contains less than 100 g/L.
We make it our mission to ship your order in a timely fashion. Due to the nature of our business and the wide variety of our product offerings we sometimes encounter stock issues. Should there be any issues getting your order shipped we will contact you to update you on the situation.
All in stock items ship within 24 business hours. If you need your order shipped sooner than that please contact us directly before placing your order.
- FedEx Priority Overnight
- FedEx Standard Overnight
- FedEx 2Day A.M
- FedEx 2Day
- FedEx Express Saver
- FedEx Ground
- Local In Store Pickup