Smith’s Poly-SEAL may be used as a primer for interior and exterior direct-to-concrete applications prior to Smith’s Poly-WB topcoat, as a seal coat to lock down Vinyl Chip prior for residential garage floor systems, finish for Terrazzo as a replacement for traditional floor wax in addition to a standalone architectural and decorative concrete sealer for concrete overlays, Stucco, pavers and more.

Smith’s Poly-SEAL is available as a standard / semi-gloss finish or an optional low sheen finish.  Solid colors can be achieved by adding Smith’s WSC Waterborne Solid Color Packs (sold separately).

RECOMMENDED USES:

• Traditional Decorative Concrete Sealer (2 coats)
• Sealer for rockscapes, carved concrete, faux stone, etc. (Low Sheen)
• Terrazzo Sealer**
• Seal Coat prior to:
  • Over Vinyl Chip Systems* prior to grout coat of Smith’s Polyaspartics or Smith’s Poly-WB (Residential Garage floors only)
  • Direct-to-Concrete Primer* for Smith’s Poly-WB with residential or light commercial traffic

APPROVED SUBSTRATES:

• Concrete, Stucco & Polymer Modified Overlays, such as Smith’s 4 in 1 Overlay
• Pavers
• Concrete Stains & Dyes (i.e. Smith’s Color Floor & Smith’s Liquid Dye)
• Terrazzo** (Cementitious & Epoxy)
• Vinyl Chip (Neat, unsealed prior to topcoat of Smith’s Poly-WB)

*Semi-gloss version only.  **Once any existing wax / floor finish has been thoroughly removed.  ***Smith’s Poly-SEAL is NOT compatible with Smith’s CRU’86, Smith’s MCU-60, Smith’s Hi-Wear 90S, or Smith’s Poly 2K-90.

HIGHLIGHTS:

• Does not enhance colors – No “Wet Look”
• Ready-to-Use
• Alkali-Resistant
• Fast Drying
• Tenacious Bond
• Low Odor & Low VOC’s
• Infinite inter-coat adhesion
• U.V. Stable – Non-yellowing
• Good Blush Resistance
• Water Submersible once fully cured
• Resists to Hot Tire Pickup (Residential Traffic only)